Servo-Check (#WD1935): The ideal tool for checking and pre-setting hobby servos. Automatic and manual modes with marker LED lighting every 15 degrees. $50.00

m-Serial Servo Driver Chip (#WD1984): This single 8-pin chip is a complete, full feature serial servo driver. Drives up to 3 servos using software syntax as above. Chip supports speed control, servo position feedback and individual servo ON-OFF switching for power management. $45.00

Hobby Servos: The unsung hero of animatronics- powerful, easy to control and low cost. May be easily modified to make a low cost variable speed dc motor. We stock a selection of hobby servos suitable for use with our serial driver modules. Call for prices.

Part #	Dimensions	Weight	Torque
#WD1957	22x11x20mm	9gms	0.8kgcm
#WD1930	40x20x36mm	42gms	3.4kgcm
#WD1944	41x20x42mm	48gms	7.2kgcm
#WD1934	55x27x52mm	114gms	10kgcm
#WD1947	63x32x62mm	136gms	13kgcm

IR Decoder Module (#WD1933): Works with any domestic IR controller. Simply train the decoder to respond to specific keys on your remote. 7 outputs selectable to be either momentary or toggle action. May be re-programmed over and over again. $65.00

Serial IR-Decoder Module (#WD1950): Similar to the above but with a serial RS232 @ 9600 baud output rather than discrete output pins. Responds to a maximum of 8 key inputs. Great for IR control of robotics etc. Simple 3-pin connection. Download the full data sheet from our web site. $48.00

Sound Card (#WD1480): Record and playback up to 8 audio passages using digital memory chip. Total message lengths up to 90 seconds. Includes mic and amp chip (250mW/8 ohms). Standard controller chip may be swapped out for a Stamp1 chip set if you wish to experiment further (typical code supplied on diskette). $80.00

Animate Card (#WD1917): Full feature animation card as used with "Alex". Up to 40 seconds of recording and playback for 4 servos and up to 4 digital outputs. On-board 20 second sound chip with microphone and speaker output. All tracks recorded sequentially for easy build up to a fully integrated display. Loop play, auto start-up and PIR-microswitch input facility. Ready built and tested. $190.00

Puppeteer Board (#WD1919): Neat little controller for single servos- up to 4 minutes recording time, loop play with variable time delay between loops, auto start-up and easy recording features. Several modules may be daisy chained together and controlled from one master module. Download the full data sheet from our web site. $60.00

Puppeteer+ Board (#WD1919+): All the features of the standard Puppet board but with an additional digital channel with a 1A /24vDC rated relay. Record your servo channel first and then superimpose the digital channel while the servo is playing.$95.00

Wizard Card (#WD1960): The WIZARD CARD will record and playback up to 5 minutes of action for up to 4 R/C type servos and 4 digital outputs. The card also incorporates features such as looping action with variable delay between loops, auto start-up on power up and connection interface for a PIR. Connection for remote switch or pressure pad to initiate playback. Recording sessions are built up on a track-by-track basis - no programming is required. During recording, all previously recorded tracks are re-played to aid synchronization. Everything your animatronic needs, but the AUTOTALK to make it speak! $175.00

FEATURES:

• 4 Servo output channels, each capable of recordin and playback of up to 5 minutes of action.
• 4 Digital channels - 0/5V @ 10ma outputs
• Potentiometer to adjust the servo positions during recording or to determine the time delay between play loops during automatic loop play - adjustable between 0 and 65 seconds.
• NEXT, PLAY and RECORD buttons
• Record enable/disable jumper
• AUTO-PLAY and LOOP-PLAY switches

Auto Talk Card (#WD1961): The AUTOTALK module will move the R/C type servo in response to either an audio or speech input signal from a CD Player, tape recorder, or speaker jack. AUTOTALK includes the facility to set both the servo end travel points and the directon of operation. Make your animatronic talk and sing! $80.00